
粉末噴涂的設備系列表
STR-NKP-1型管內腔靜電粉末噴涂器 Spraying machine for piping inner wall
◆適用性時間范圍 Applicable scope
實應用在小眼及小型線路的罐壁油漆,它是采取無氣粉末噴涂機輸送機來的高電壓油漆,確認珍品的噴水嘴,使油漆霧化吸入后可以直接行成麥克風形(園球形、中空),不均地噴在線路內表面能,所以構建線路的油漆。 NKP-1型注意可使用Ф50-Ф300mm的pvc管道,真石漆凝固點允許超出80秒(4號福特杯)。假如建筑涂料107硅橡膠粘度大于80秒,用加石油醚搖勻。NKP-1型一般上不易受到途徑長寬高影響,但合適不立于15米。
Apply YuXiaoKong and medium pipe wall coating, it is to use it without gas transmission to high voltage coating, through the special nozzle, to make the paint spray directly formed after flared (garden tapered, hollow), evenly spray in the pipe inner surface, so as to realize the pipe coating. NKP-type 1 is mainly used in Ф 50-Ф 300 mm pipe, coating viscosity shall not be higher than the 80 seconds (4 ford cup). If the paint is higher than 80 seconds, viscosity should be diluted solvent. NKP-type 1 basically from piping length restrictions, but had better not longer than 15 meters.
|
粉末噴涂地埋管里孔范圍之內Spray pipe hole range(mm):Ф50-300 |
|
車身長寬Fuselage length (mm):Ф50×280(長) |
|
后殼體積Body weight (kg):0.9 |
|
水性涂料把握轉換開關手噴槍總重Coating control switch hand gun weight(weight):0.45 |
進行安裝方框圖 Installation to which
|
氣源 Gas source |
|
氣體緩解壓力閥 Air pressure reducing valve |
|
油和水份離器 Oil-water separator |
|
無氣噴塑機 No gas |
| |||||
|
|
|
|
| |||||||||
|
|
|
|
|
|
|
|
| |||||
|
|
|
|
|
|
|
|
| |||||
|
|
高壓變壓器橡膠軟管 High-pressure hose |
|
NKP-1 空洞噴塑器 Hole spraying device |
|
手噴槍 Hand gun |
|
噴咀 Wards | |||||